1. The orientation of the two claw blocks and the gear plate can be adjusted, the claw block moves upward, the pressure increases, each action of the claw block is one tooth, and the distance between the two surfaces changes by about 0.1 mm. Generally, there is only one tooth when the action is adopted.
2. When the claw block is in the position of the tooth plate to the last tooth, you should consider replacing the new gear and the bias distance. The following methods can be used to adjust: loosen the screw to loosen the gear deflection adjustment plate, gear wrench to make the machine back gear deflection.
Then watch out: the number of teeth on both sides should rotate equally, rotating no more than three teeth. The tooth adjustment plate, screw and claw block of the equipment will be adjusted to the first tooth. Looking at the shear pressure effect, the effect is not satisfactory. If you can make the adjustment, you should pay attention to the teeth of the rotating gear, which should be smaller than the first rotating teeth.
When the pressure on the left or right side is too low, this method can also be used, that is, small pressure can be used to adjust which side and which side of the gear has migraine. Try to cut the claw block and return 1-2 teeth properly.
3. When the upper and lower parts of the pressure, release pad and hook type fastening plate adjustment screw block, hook type pad increase the thickness of the gasket together to reduce the plate thickness of the gasket in the cavity of the block, facing the increasing pressure of the work surface unit; on the contrary, low pressure.
